HONDA GX200 - Manual (Page 9)

ENGLISH
REDUCTION CASE OIL (applicable types)
Recommended Oil
Oil Level Check
Oil Level Check
Oil Change
2 : 1 Reduction Case With Centrifugal Clutch
WASHER
OIL LEVEL
DRAIN PLUG
OIL FILLER CAP/
DIPSTICK
UPPER LIMIT OIL FILLER CAP/DIPSTICK
LOWER LIMIT
OIL FILL HOLE
(bottom edge)
LOWER LIMIT
UPPER
LIMIT
FILLER CAP/DIPSTICK
9
Install the oil filler cap/dipstick and tighten securely.
Use the same oil that is recommended for the engine (see page ).
Check the reduction case oil level with the engine stopped and in a
level position.
Remove the oil filler cap/dipstick and wipe it clean.
Insert and remove the oil filler cap/dipstick without screwing it
into the filler hole. Check the oil level shown on the oil filler cap/
dipstick.
If the oil level is low, add oil to reach the upper limit mark on the
dipstick with the recommended oil.
Screw in the oil filler cap/dipstick and tighten securely.
Check the engine oil level with the engine stopped and in a level
position.
Remove the oil filler cap/dipstick and wipe it clean.
Insert the oil filler cap/dipstick into the oil filler neck as shown,
but do not screw it in, then remove it to check the oil level.
Reinstall the oil filler cap/dipstick.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash, pour it on the ground,
or down a drain.
Allow the used oil to drain completely, then reinstall the oil drain
plug and new washer, and tighten the oil drain plug securely.
Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick, oil drain plug and washer.
Drain the used oil when the engine is warm. Warm oil drains
quickly and completely.
The Oil Alert system (applicable types) will automatically stop the
engine before the oil level falls below the safe limit. However, to
avoid the inconvenience of an unexpected shutdown, always
check the engine oil level before startup.
Running the engine with a low oil level can cause engine damage.
Running the engine with a low oil level can cause engine
damage.
The Oil Alert system (applicable types) will automatically stop
the engine before the oil level falls below the safe limit.
However, to avoid the inconvenience of an unexpected
shutdown, fill to the upper limit, and check the oil level regularly.
With the engine in a level position, fill to the upper limit mark
(bottom edge of the oil fill hole) on the dipstick with the
recommended oil (see page
).
If the oil level is near or below the lower limit mark on the
dipstick, fill with the recommended oil (see page
) to the
upper limit mark (bottom edge of the oil fill hole). Do not overfill.
1.
2.
3.
4.
3.
4.
1.
2.
1.
2.
3.
4.
8
8
8
05/06/17 17:24:44 32Z4F601_009