Hawking Technology HNC290G - Manual (Page 38)

38
Setting Wizard
Internet Camera Name The default camera name is “HNC230G”. It is recommended that you
enter a name for the camera that is easy to remember.
IP Address The wizard will automatically set an available IP Address for the
camera. For example, if the IP address scheme for your network is
192.168.2.x, the wizard will search an unused IP Address between
192.168.2.0 and 192.168.2.250, and assign the camera an available IP
Address.
You may enter another IP Address to change the setting.
Subnet Mask The wizard will auto search the network’s Subnet Mask setting and set
the camera to the same Subnet Mask.
You may enter another Subnet Mask to change the setting.
Gateway The wizard will auto search the network’s Gateway setting and set the
camera to use the same Gateway.
You can enter another Gateway to change the setting.
Video Port This defines the video stream port. The default port number is “5000”.
Cancel Click “Cancel” to quit the Wizard Setting window.
Finish Click “Finish” to complete the camera settings.
When you finish with the camera settings, you can click “Ok” to run the “Camera Viewer” immediately or click “Cancel”
to run the “Camera Viewer” later.