Hawking Technology HNC290G - Manual (Page 57)

57
The HNC290G features built-in motion detection with snapshot emailing. In order to utilize this feature, you will have to
enable it either in the “Network Settings” section of the camera’s web UI, or in the “Motion Detection” section of the
Administrator Utility, as shown in the figure below. Once enabled, the system will email still image snapshots to the
person or party specified in the “Email Address” field, as detailed in the “Change Email Account” section from the
previous page in this user’s manual. The user can define the number of snapshots to be emailed for each detected event,
as well as the frequency with which he/she wants events to be detected. Please see the instructions below.
Motion Detection
Enable Motion Detection Motion detection is disabled by default. Click on “Enable” to begin
using the motion detection function.
Frames per Event Detection
Interval Between Next Event
Detection (secs.)
Apply
In this field, the user can select the number of still-image snapshots
he/she would like to be emailed per instance of detected motion. The
field is set at “3” by default.
In this field, the user can select the interval of time, in seconds, he/she
would like between consecutive events for motion detection. The
default setting is “10 seconds”. Please note that this camera does not
have the capability to detect motion continuously.
When you finish in the “Motion Detection” section, click “Apply”.