Hitachi 1000 - Manual (Page 29)

www.hitachi.com BladeSymphony 1000 Architecture White Paper 29
Figure 20. Embedded Fibre Channel Switch Module block diagram
The Embedded Fibre Channel Switch Module is configured with three components: A Brocade Fibre
Channel switch, Fibre Channel HBAs, and network adapters. Directly connecting the HBAs to the FC
switch in this manner, rather than installing them as PCI cards in the blades eliminates the 16 fiber
cables that would be necessary to make these connections in other systems, as illustrated in Figure 21.
Another benefit is reduced latency on the data path. This dramatically reduces complexity,
administration, and points of failure in FC environments. It also reduces the effort to install and/or
reconfigure the storage infrastructure.
48V
12V
Gl acier
5V
12V
3.3V
12V (main)
5V (Standby)
FC - SW
Processor
CPLD
else
SFP
SFP
SFP
SFP
RJ45
For management
RS232C
Connector
I2C
Hub
I2C
Reg.
I2C
UART
I2C
Local Data Bus
Total 8 modules mountable
PCIeX4 (Server blade #0)
PCIeX4 (Server blade #1)
PCIeX4 (Server blade #2)
PCIeX4 (Server blade #3)
PCIeX4 (Server blade #4)
PCIeX4 (Server blade #5)
PCIeX4 (Server blade #6)
PCIeX4 (Server blade #7)
LED
ROM
82,546 GB
(GbE)
LAN
RJ45+(MAG)
PCI-X
64b 100MHz
PCI-X
64b 6MHz (4Gbs)
41210
Bridge FC 4.25 Gbs (Max)
Con.
Five
Flash
PCI-Exp (x4)