Hearth and Home Technologies SL-350TRSI-AUE - Manual (Page 18)

18
Heat & Glo • SL-350TRSI-AUE • 2089-902 Rev. B • 6/06
!
WARNING: ENSURE THAT THE HEATER
GASKET SUPPLIED WITH THE HEATER
SEALS BETWEEN THE FIRST FLUE COMPO-
NENT AND THE OUTER HEATER WRAP.
Fire Risk
Exhaust Fumes Risk
Impaired Performance of Appliance
• Overlap pipe slip sections at least
38 mm.
• Screws must not exceed one inch long.
• Pipe may separate if not properly
joined.
WARNING
Installing Flue Components
A. On the REAR of the heater
1. Attaching the First Flue Component to the Start-
ing Collars:
To attach the first flue component to the starting collars
on the rear of the heater:
• Make sure that the flue gasket supplied with the
heater seals between the first flue component and
the outer heater wrap.
• Slide the male end of the inner flue of the pipe sec-
tion over the inner collar on the heater. At the same
time, slide the outer flue over the outer collar on the
heater. Push the flue section into the appliance col-
lar until all the lances (see Figure 19) have snapped
in place. Tug slightly on the flue to confirm that it
has completely locked into place.
Figure 19.
• Any 90 0 elbow installed directly onto the rear flue of
the heater MUST BE in a vertical position.
2. Assembling Flue Components
Insert the inner flue of section A into the flared inner flue
of section B.
Start the outer flue of section A over the outer flue of
section B (see Figure 20). Note: The end of the pipe
sections with the lances/tabs on it will face towards
the appliance.
Once both inner and outer flues are started, press sec-
tion A onto section B firmly until all lances have snapped
into place. Check to make sure they have snapped
together (see Figure 21) and the seams are not aligned
(see Figure 22). Tug slightly on section A to confirm it
has completely locked into place.
Figure 20. Figure 21.
A
B
Н