Hitachi AA 2000 - Manual (Page 19)

307-586 19
Spray Tip and Air Cap Selection Charts
SOLID STREAM SPRAY TIPS
For use in applications requiring a solid stream of fluid such
as with mastics or sealers. All these tips require
Air Cap
218–336 .
Orifice Size
inches (mm)
Part No. Pattern
0.027 (0.689) 182–027
0.029 (0.737) 182–029
0.031 (0.787) 182–031
0.033 (0.838) 182–033
0.035 (0.889) 182–035
0.037 (0.940) 182–037
0.039 (0.991) 182–039
0.041 (1.041) 182–041
0.043 (1.092) 182–043
0.045 (1.143) 182–045
0.047 (1.194) 182–047
Solid stream,
approximately
0.25" (6.35 mm)
FINE FINISH SPRAY TIPS
For use in application of certain urethanes, clearcoats, and
light-weight air-dry enamels.
All these tips require replace-
ment of standard diffuser-seat with Diffuser-seat part no.
223–139.
Orifice Size
inches (mm)
Light Viscosity
fl oz/min*
(liters/min)
Fan Width at
12” (300 mm)
inches (mm)
Fine Finish
Spray Tip
Part No.
0.012 (0.305) 10.0 (0.3) 6–8
(152–203)
182–312
0.014 (0.356) 13.6 (0.4 6–8
(152–203)
182–314
0.012 (0.305) 10.0 (0.3) 10–12
(250–300)
182–512
0.014 (0.356) 13.6 (0.4 10–12
(250–300)
182–514
0.016 (0.406) 17.0 (0.5) 10–12
(250–300)
182–516
0.018 (0.457) 20.9 (0.6) 10–12
(250–300)
182–518
0.020 (0.508) 25.8 (0.8) 10–12
(250–300)
182–520
* Fluid output at 600 psi (41 bar).
AIR CAPS
Tip Size
Used With Air
Application inches (mm) Consumption Part No.
smaller than
Standard 0.025 (0.635) 3–5 scfm 217–303 {
0.027 (0.689)
Standard and larger 3–5 scfm 218–336
smaller than
Fine Finish 0.025 (0.635) 5–7 scfm 219–093 {{
smaller than
High Solids 0.025 (0.635) 5–7 scfm 219–094
Fine Finish
with Pattern
smaller than
Adjustment 0.025 (0.635) 5–7 scfm 222–507
High smaller than
Atomization 0.025 (0.635) 5–7 scfm 222–607
High Effi-
ciency Low
smaller than
Pressure t 0.025 (0.635) 5–7 scfm 222–608
{ Air cap provided with spray gun.
{{ The pattern adjustment valve must be open (turned fully
clockwise) when using this air cap.