Hitachi AA 2000 - Manual (Page 20)

20ą307-586
Accessories
Use Only Genuine Graco Parts and Accessories
Four Finger Trigger 183–104
Longer than standard trigger. Reduces trigger pull
when spraying mastics and heavy fluids.
Replaces
item 3, in the parts list, page 17.
Plastic Ball Tipped Fluid Needle 220–413
For fluid pressures below 500 psi (35 bar) and light
viscosity fluid.
Replaces item 5, in the parts list,
page 17.
Ruby Ball Tipped Fluid Needle 222–497
For use with acid catalyzed finishes.
Replaces item 5,
in the parts list, page 17.
Fluid Needle Compression Spring 106–452
For spraying higher solids or heavier viscosity fluids.
Replaces item 24, in the parts list, page 17.
Ultra High Molecular Weight Polyethylene Needle
Packing Kit 221–150
Use to replace needle packings
(item 47, in the parts
list, page 17) when spraying urethane fluids. Helps
eliminate isocyanate crystallization in packing area.
Grounding Clamp and Wire 222–011
12 ga, 25 ft (7.6 m) wire
Brush 101–892
For cleaning the gun.
High Pressure Ball Valves, Viton
r
Seals
5000 psi (350 bar) Maximum Working Pressure
Can be used as fluid drain valve.
210–657 1/2 npt(m)
210–658 3/8 npt(m)
210–659 3/8 x 1/4 npt(m)
In-line Fluid Filter 210–500
5000 psi (350 bar) Maximum Working Pressure
100 mesh. Fits onto the gun’s fluid connector. 1/4–18
npsm.
168–517
Filter
164–075
210–501
205–264
Bleed-type Master Air Valve
300 psi (21 bar) Maximum Working Pressure
Relieves air trapped in the air line between the pump
air inlet and this valve when closed.
107–141 3/4 npt(m x f) inlet & outlet
107–142 1/2 npt(m x f) inlet & outlet