Homelite UT80715 - Manual (Page 5)

3 — English
WARNING:
Read and understand all instructions. Failure to follow
all instructions listed below may result in electric shock,
fire, and/or serious personal injury.
WARNING:
When using this product basic precautions should always
be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
THIS PRODUCT
 To reduce the risk of injury, close supervision is neces-
sary when a product is used near children.
 Be thoroughly familiar with controls. Know how to stop
the product and release pressure quickly.
 Stay alert and exercise control. Watch what you are
doing and use common sense. Do not operate product
when you are tired. Do not rush.
 Do not operate the product while under the influence
of drugs, alcohol, or any medication.
 Keep the area of operation clear of all persons,
particularly small children, and pets.
 Don’t overreach or stand on unstable support. Keep
proper footing and balance at all times.
 Follow the maintenance instructions specified in this
manual.
 This product is provided with a ground fault circuit
interrupter built into the power cord plug. If replace-
ment of the plug or cord is needed, use only identical
replacement parts.
 WARNING: Risk of injection or injury – Do not direct
discharge stream at persons.
SAVE THESE INSTRUCTIONS
GROUND FAULT CIRCUIT INTERRUPTER
PROTECTION
This pressure washer is provided with a ground fault circuit
interrupter (GFCI) built into the plug of the power supply
cord. This device provides additional protection from the risk
of electric shock. Should replacement of the plug or cord
become necessary, use only identical replacement parts that
include GFCI protection.
SERVICING OF A DOUBLE-INSULATED
APPLIANCE
In a double-insulated product, two systems of insulation
are provided instead of grounding. No grounding means is
provided on a double-insulated product, nor should a means
for grounding be added to the product. Servicing a double-
insulated product requires extreme care and knowledge of
the system, and should be done only by qualified service
personnel. Replacement parts for a double insulated prod-
uct must be identical to the parts they replace. A double-
insulated product is marked with the words “DOUBLE
INSULATION” or “DOUBLE INSULATED.” The symbol
may also be marked on the product.
WARNING: To reduce the risk of electrocution, keep all
connections dry and off the ground. Do not touch plug with
wet hands.
IMPORTANT SAFETY INSTRUCTIONS