Hotpoint SE48R1012GX - Manual (Page 14)

14
GB
Sliding rack kit assembly
To assemble the sliding racks:
1. Remove the two
frames, lifting them
away from the spacers
A (see figure).
2. Choose which shelf
to use with the sliding
rack. Paying attention
to the direction in which
the sliding rack is to be
extracted, position joint
B and then joint C on
the frame.
3. Secure the two
frames with the guide
rails using the holes
provided on the oven
walls (see diagram).
The holes for the left
frame are situated at
the top, while the holes
for the right frame are
at the bottom.
4. Finally, fit the frames on the spacers A.
 Do not place the sliding racks in position 5.
D
B
C
Left
guide rail Right guide
rail
Di
rect
ion
of
e
xtract
ion
A
Assistance
Warning:
The appliance is fitted with an automatic diagnostic
system which detects any malfunctions.
Malfunctions are displayed by messages of the
following type: “ER” followed by numbers.
Call for technical assistance if a malfunction occurs.
Before calling for Assistance:
• Check whether you can fix the problem yourself.
• Restart the programme to check whether the
malfunction has disappeared.
• If it has not, contact the Authorised Technical
Assistance Service.
 Never use the services of an unauthorised
technician.
Please have the following information to hand:
• The message shown on the TEMPERATURE
display.
• The appliance model (Mod.).
• The serial number (S/N).
The latter two pieces of information can be found on
the data plate located on the appliance.