Hotpoint SE48R1012GX - Manual (Page 2)

2
GB
 Before operating your new appliance please read
this instruction booklet carefully. It contains
important information concerning the safe operation,
installation and maintenance of the appliance.
 Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
Positioning
 Keep all packaging materials out of the reach of
children. It may present a choking or suffocation
hazard (see Precautions and tips).
 The appliance must be installed by a qualified
person in compliance with the instructions provided.
Incorrect installation may cause harm to people and
animals or may damage property.
Built-in appliance
Use the appropriate cabinet to ensure that the
appliance functions properly.
• The panels adjacent to the oven must be made of
heat-resistant material.
• Cabinets with a veneer exterior must be
assembled with glues which can withstand
temperatures of up to 100°C.
• To install the oven under a counter (see diagram)
or in a kitchen unit, the cabinet must have the
following dimensions:
 If the appliance is fitted
under the counter, make sure
that the hob piping is
positioned correctly and that it
does not interfere with the
oven during installation or
obstruct the rear vents of the
cooling fan.
 The appliance must not come into contact with
electrical parts once it has been installed.
The indications for consumption given on the data
plate have been calculated for this type of installation.
Ventilation
To ensure adequate ventilation is provided, the back
panel of the cabinet must be removed. It is
advisable to install the oven so that it rests on two
strips of wood, or on a completely flat surface with
an opening of at least 45 x 560 mm (see diagrams).
Centring and fixing
Position the 4 tabs on the side of the oven so that
they are lined up with the 4 holes on the outer frame.
Adjust the tabs according to the thickness of the
cabinet side panel, as shown below:
20 mm thick: take off the
removable part of the tab (see
diagram).
18 mm thick: use the first
groove, which has already
been set in the factory (see
diagram).
560 m
m.
45 mm.
Installation
480 mm.
595 m
m.
24,5 mm.
545 mm.
3 mm.
470 mm.
7 mm.
475 mm.
45 mm.
558 mm.
547 m
m. m
in.
OK OK