hussmann P/N 0420057_B - Manual (Page 10)

Leveler Adjustment
Position the first case at the highest point.
Set a long level (4 ft [1220 mm] or more)
on the upper front panel of the case. Use an
open-end wrench to turn leg levelers until
the case is level from end to end and from
front to back. Check all 6 legs on 8 ft (2438
mm) cases, or 8 legs on 12 ft (3658 mm)
cases.
Note: To avoid removing concrete flooring,
begin lineup leveling from the highest point
of the store floor.
Attention to glass position is critical
during the leveling process.
Adjusting leg levelers will affect the
position of the glass. Make certain that the
glass is square with the case, avoiding
interference with other glass and case ends.
If the glass is still out of alignment, refer to
the following Glass Positioning instructions.
1-4 I
NSTALLATION
P/N 0420057_B
U.S. & Canada 1-800-922-1919 • Mexico 1-800-522-1900 • WWW.HUSSMANN.COM
M INIMUM
H
EIGHT
M AXIMUM
H
EIGHT
Adjustable
Leg Leveler
Lower Raise
Level on
Upper Front
Panel
U
Leg
Leveler
Glass Glass
Movement
To prevent injury from falling
glass during adjustment, one
person must support glass
while a second person makes
adjustments.
CAUTION !
Do not adjust glass until case is level.
In many instances, proper leveling will align
glass without further adjustment.
NOTICE