hussmann P/N 0420057_B - Manual (Page 16)

3. Align the assembly on the back of the case
as shown below.
4. Using holes in wrapping board bracket as a
template, mark hole locations on rear of case.
5. Remove wireway cover; make sure there
are no wires behind hole locations.
6. Drill 3 /
8
-inch (0.1875) diameter holes for
three 1 / 4 -20 thread cutting screws through stain-
less steel and structural members.
7. Securely fasten brackets to case.
8. Adjust wrapping board as needed. The attach
points for hinging brackets on wrapping board is
determined by which position the assembly is to
be mounted. Refer to figures for LH, RH or
Center mounting positions. 9. Replace wireway cover.
10. Restore power.
1-10 I
NSTALLATION
P/N 0420057_B
U.S. & Canada 1-800-922-1919 • Mexico 1-800-522-1900 • WWW.HUSSMANN.COM
Screw - 1 / 4 -20 x 0.5-in.
Hex Head Zinc Plate
(2 required for each bracket)
Bracket - Adj
(2 required)
Mounting Holes
Bracket Spacer
(2 required)
Screw - 1 / 4 -20 x 0.75-in.
Flange Thread Cutting
(3 required for each bracket)
Screw - #8 x 1 / 2
PHIL AB SMS
(3 required for
each bracket)
Wrap Board Panel
Wrapping Board Assembly for Mounting to Right Hand Side of Case
(Facing Front of Case)
Screw - 1 / 4 -20 x 0.5-in.
Hex Head Zinc Plate
(2 required for each bracket)
Bracket - Adj
(2 required)
Mounting Holes
Bracket Spacer
(2 required)
Screw - 1 / 4 -20 x 0.75-in.
Flange Thread Cutting
(3 required for each bracket)
Screw - #8 x 1 / 2
PHIL AB SMS
(3 required for
each bracket)
Wrap Board Panel
Wrapping Board Assembly for Mounting to Center of 12-Ft Case
or Mounting in Positions Other Than Left, Right or Center of Case
(Facing Front of Case)
Wrap Board Panel
Screw - 1 / 4 -20 x 0.5-in.
Hex Head Zinc Plate
(2 required for each bracket)
Bracket - Adj
(2 required)
Mounting Holes
Bracket Spacer
(2 required)
Screw - 1 / 4 -20 x 0.75-in.
Flange Thread Cutting
(3 required for each bracket)
Screw - #8 x 1 / 2
PHIL AB SMS
(3 required for
each bracket)
Wrapping Board Assembly for Mounting to Left Hand Side of Case
(Facing Front of Case)
8.969 for 36-in. Board
8.656 for 48-in. Board
REF
0.125-in.
Diameter
Bottom View of Wrap Board Panel
0.812
3.25
REF
0.812
8.969 for 36-in. Board
8.656 for 48-in. Board
REF
Drill 6 additional holes 0.5-in. deep
if not already existing in wrapping board.