Humax HFA100 - Manual (Page 10)

**
Follow these instructions to install your HFA100 digital television receiver.
**
**
Input Connections
**
Connect an antenna to the F-type connector on the rear of the HFA100. This antenna can be mounted on a
roof, in an attic, or another appropriate location. It should be aimed towards local DTV broadcast stations for
best results.
DTV stations broadcast on both VHF (2-13) and UHF (14-69) channels. Make sure to use an antenna that
works at the desired frequencies so the HFA100 can pick up any DTV broadcasts on those channels. (See
appendix for local DTV broadcast channel information.)
**
Output Connections
**
First, see if your TV has an HDMI input connector, a special all-digital interface that provides the highest
picture quality. If so, you will want to connect an optional HDMI interface cable from the HFA100 to your TV's
HDMI input.
If an HDMI input connector is not present, then connect an analog component video cable from the output
jacks on the rear of the HFA100 to your TV's component video inputs. You may use either a three-wire
(YPbPr) cable or a five-wire RGB cable, depending on which connectors are available on your TV.
If you are using a standard analog TV that does not have component video inputs, connect either a S-video or
composite (yellow) cable from the HFA100 to your analog TV.
For digital audio connections, use either the coaxial RCA or optical Toslink connector to bring Dolby Digital
audio to your TV or AV receiver. If digital audio connections are not available, use either of the pair of stereo
RCA jacks to connect audio to your TV.
**
Installing Your HFA100
9
**
**
**
**
**
**
**
**
**
**
**
**
**
**