Hilti TE 7-C - Manual (Page 8)

Power tool TE 7
‑C
Rated voltage 120 V
Rated current input 6.3 A
Mains frequency 60 Hz
Weight of the tool, including side handle 3.5 kg
Dimensions (L x W x H) 341 mm x 86 mm x 217 mm
Drilling speed without hammering 0…900/min
Hammer drilling speed 740/min
Single impact energy 2.6 J
Other information about the power tool
Chuck TE
‑C Click
Drilling performance in medium-hard concrete
Ø 16 mm: 56 cm³/min
Protection class Protection class I (grounded) or protection class II
(double insulated). See type identification plate.
5. Safety instructions
NOTE
contain all general safety rules for power tools which,
in accordance with the applicable standards, require
to be listed in the operating instructions. Accordingly,
some of the rules listed may not be relevant to this
tool.
5.1 General Power Tool Safety Warnings
a)
WARNING
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury. Save all warnings and instructions for
future reference. The term “power tool” in the
warnings refers to your mains-operated (corded)
power tool or battery-operated (cordless) power
tool.
5.1.1 Work area safety
a) Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while oper-
ating a power tool. Distractions can cause you to
lose control.
5.1.2 Electrical safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets
will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet con-
ditions. Water entering a power tool will increase
the risk of electric shock.
d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges
or moving parts. Damaged or entangled cords
increase the risk of electric shock.
e) When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of
a cord suitable for outdoor use reduces the risk
of electric shock.
f) If operating a power tool in a damp location
is unavoidable, use a residual current device
(RCD) protected supply. Use of an RCD reduces
the risk of electric shock.
en
5