Husky A05051 - Manual (Page 14)

14- ENG A05051
How to Start:
1. Turn the Off/Auto-On switch to
"Auto-On" and allow tank
pressure to build. Motor will
stop when tank pressure reaches
"cut-out" pressure.
2. Turn the regulator knob
clockwise until desired pressure
is reached. NOTE: To use the
suggested pressure readings on
the label, turn the regulator knob
clockwise until the needle on the
pressure gauge aligns with the
desired suggested pressure
reading number.
Before Each Start-Up:
1. Place Off/Auto-On switch to
"Off" and close air regulator.
2. Turn the regulator knob
counterclockwise until it stops.
3. Attach hose and accessories.
Risk of Bursting.
Too much air
pressure causes a hazardous risk
of bursting. Check the
manufacturer’s maximum pressure
rating for air tools and accessories.
The regulator outlet pressure must
never exceed the maximum
pressure rating.
How to Use Telescopic Handle
and Wheels for Easy Mobility
1. Press the release button and
slide handle out until it locks into
place.
2. Pull or push unit as shown.
IMPORTANT: This handle is for
pushing or pulling the unit. DO
NOT lift the unit by this handle.
3. To lower handle, press the
release button and push handle
until it snaps into place for
storage.
3. The compressor is ready for use.
needle
4. Open the drain valve fully
(counterclockwise) to permit air
to escape and prevent air
pressure build up in the air tank
during the break-in period.
5. Move the Off/Auto-On switch to
"Auto-On" position. The
compressor will start.
6. Run the compressor for 15
minutes. Make sure the drain
valve is open and there is
minimal air pressure build-up in
tank.
7. After 15 minutes, close the drain
valve (clockwise). The air receiver
will fill to "cut-out" pressure and
the motor will stop.
The compressor is now ready for use.