Honeywell TE821WD - Manual (Page 22)

22
yesterday, past week or past month.
Note: Last Hour rainfall value is displayed as a rate of rain in either “inch/hr” or “mm/hr”.
Rainfall Memory Reset
With the rain icon flashing, press and hold the MEMORY button to reset all rainfall statistics.
Setting Rain Display; inches or mm
With the rain icon flashing, press and hold the SET button to toggle rainfall data units between mm and inches.
Enabling or Disabling Daily Rainfall Alert
· With the rain icon flashing, press the ALARM/CHART button to display either the current rainfall statistics or the daily
rainfall alert with “ALARM HI” displayed.
· If the alert is disabled, the “OFF” will be displayed; otherwise the rainfall alert value will be shown.
· When the rainfall alert is displayed, press the UP or DOWN arrow button to enable or disable it.
Setting up Daily Rainfall Alert
· With the rain icon flashing, press ALARM/CHART button to display the rainfall alert.
· Press and hold ALARM/CHART button until the rainfall alert “ALARM HI” will flash.
· Set the desired value for the Rainfall Alert by using UP or DOWN arrow button. Press and hold either button for fast
digits advance.
· Press ALARM/CHART button to confirm selection and the unit will return to the rainfall alert display.
Disabling the Daily Rainfall Alert
In the Daily Rainfall Alert Mode press the ALARM/CHART button to disable the alert.
Wind Window
Wind direction is shown by compass points (i.e. NW) or in bearings starting from north (i.e. 22.5º). The unit displays
anemometer temperature or wind chill, average wind speed (over the past 10 minutes), gust, and wind other information. It
records the maximum wind speed and gusts collected during the day. Wind speed and gust alerts can be programmed based
on pre-configured limits. Wind speed is displayed in km/h, mph, m/s or knots
.
Selecting Wind Window
Press main unit UP or DOWN until the WIND icon on the display starts flashing.