Harbor Freight Tools 95797 - Manual (Page 3)

Page 3 SKU 95797 for technical questions, please call 1-800-444-3353
intended function. Any broken parts or mounting fixture that may affect proper operation
should be properly repaired or replaced by a qualified technician.
properly disponse of any used batteries. Dispose of the used batteries properly
according to the solid Waste disposal regulations in your community.
warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
uNpACKiNG
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of
this manual as soon as possible.
OpERATiNG iNSTRuCTiONS
NOTE: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram on page 7.
Before using, you need to charge the batteries. You can do this by placing the Solar
Lantern in the sunlight. The Lantern will take approximately 8 hours of sunlight to charge.
Be sure the four Solar Panels (2) are in full sunlight.
FIGURE 1
Top Assembly
Plastic Ring (11)
Solar Panels (2)
After the Batteries (8) are charged, remove the Top Assembly (See Figure 1) by twisting
counterclockwise off the Plastic Ring (11) and lifting it off the Lantern.
10.
11.
1.
2.