Humax CX PVR-9200C - Manual (Page 72)

10.4 Search
1. Select Search and press the OK button to activate channel
search.
2. Wait until channels search is completed. This may take a few
minutes.
3. The cursor is located at Stop during channel search. If you press
the OK button while performing channel search, the
operation will stop and only the channels found so far will be
displayed. Reset the settings and activate channel search again if
necessary.
4. You can delete unnecessary channels from the searched
channels. Select the channels to delete and press the OK
button. Then select Delete and press the OK
button. To
delete all channels, select Select All to select all channels, select
Delete and press the OK button.
5. When completing channel search and deleting unnecessary channels, select Save and press the OK button
to save the results.
GB 71