Specifications – Hatco Sanitizing Sink Heaters Food Rethermalizers/Bain-Marie Heaters Hatco 3CS2 User Manual
Page 8
SPECIFICATIONS
6
Form No. HHM-1103
SIZING INFORMATION
Hatco recommends the following guidelines be used
to ensure proper operation and sanitation.
For 3CS2 Series in a Manual Warewashing
Application
• Minimum 2000 watts (2 kW) per square foot
(.2 watts per sq. mm) of vessel top.
• 3CS2 units are sized based on a 140ºF (60ºC) supply
water with a 30 minute preheat period to reach
the sanitizing temperature.
For FR2 Series in a Bain-Marie or Steam Table
Application
• Minimum 750 watts (.75 kW) per square foot
(.08 watts per sq. mm) of vessel top.
For FR2 Series in a Food Rethermalizer Application
• Minimum 2000 watts per square foot (.2 watts
per sq. mm) of vessel top.
NOTE: Use one 3CS2 or FR2 unit for a vessel
up to 6' (1829 mm) long. Over 6' (1829 mm) minimum
two units required.
See the Minutes To Heat Table to determine the amount
of time required to heat water using a FR2 series
in a Bain-Marie or Steam Table application.
DIMENSIONS
A
B
D
ELECTRICAL
Install a fused disconnect switch or circuit breaker sized
according to the applicable Electrical Rating Chart.
The wiring from the switch or circuit breaker
to the Hatco unit must be in accordance with local
electrical requirements and codes
WARNING
For proper electrical installation conforming
to local electrical codes consult a licensed electrical
contractor. Improper electrical connections
may cause a serious electrical shock injury
or may damage the unit.
Models come complete with all electrical wiring
and are equipped with three electrical knockouts,
one at the rear and one on each side towards the rear.
When performing installation, run electrical connections
through one of these knockouts.
NOTE: Auto-fill models provided with two electrical
knockouts, one at the rear and one on the right hand
side towards the rear.
Only models FR2-3 and FR2-4 heaters can be ordered
and supplied with an electrical cord and plug.
Width (A)
Width (B)
Depth (C)
Height (D)
6-3/4"
7-3/4"
17-1/8"
12-3/8"
(172 mm)
(197 mm)
(435 mm)
(314 mm)
A
B
D
Width (A)
Width (B)
Depth (C)
Height (D)
6-3/4"
8-1/2"
17-1/8"
12-3/8"
(172 mm)
(216 mm)
(435 mm)
(314 mm)
Figure 4. Dimensions without Auto-fill
Figure 5. Dimensions with Auto-fill
C
C