3100 wood stove series (acc), C. firebrick replacement – Hearth and Home Technologies 31ST-ACC User Manual
Page 34
Page 4
7033-277F
September 1, 2008
R
3100 Wood Stove Series (ACC)
Replace the firebrick if they become crumbly and/or if there
is a 1/4 inch (6.5mm) gap between the bricks.
Inspect the firebrick after each ash removal.
The firebox is lined with high quality firebrick, which has
exceptional insulating properties. There is no need to use a
grate; simply build a fire on the firebox floor. Do not operate
appliance without firebrick.
1. After the coals have completely cooled, remove all old
brick and ash from unit and vacuum firebox.
2. Remove new brick set from box and lay out to diagram
shown.
. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of firebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side
of firebox and push the bottom of the brick until it is flush
with the side of the appliance.
C. Firebrick Replacement
Use Part 82-0550 when ordering individual brick. Provide brick
dimension or copy this page, mark the desired brick and take it
to your authorized dealer.
No.
Brick Size
Qty
1
9 x 4-1/2 x 1-1/4
12
2
6 x 4-1/2
4
3
9 x 4-1/2 with angle (see drawing)
1
4
9 x with angle (see drawing)
1
No.
Brick Size
Qty
1
9 x 4-1/2 x 1-1/4
10
2
6 x 4-1/2
4
3
9 x 4-1/2 with angle (see drawing)
1
4
4-1/2 x 4-1/2 x 1-1/4
2
5
9 x with angle (see drawing)
1
1
1
1
1
1
1
1
1
1
2
2
2
2
3
4
1
1
1
3
5 in.
2 in.
2 in.
1-1/4 in.
9 in.
1-1/4 in.
8 in.
3 in.
1-1/4 in.
4
Figure 34.2 - 3100 Step Top Brick Assembly
Figure 34.1 - 3100 Millennium Brick Assembly
NOTE: The Ash Removal System is avail-
able for the Step Top Model only and not
for the Millennium Model.
3
5 in.
2 in.
2 in.
1-1/4 in.
9 in.
1-1/4 in.
2
2
2
2
1
1
1
1
1
1
1
1
1
1
4
4
5
3
No brick, ARS
Grate Location
8 in.
3 in.
1-1/4 in.
5