haier AB422BCBAA - Manual (Page 6)

Wire Controller
14.Network control display
Used to adjust the time of
timer and clock
When the wire controller
a p p e a r s a b n o r m a l
condition, use a sharp-
pointed article to press
this button to make the
wire controller resume
normal
After cleaning the air inlet,
press this button, the unit
can start to operate
12.Humidifying state display
Used to turn on/off unit
1.ON/OFF button
6.Air filter cleaning display
*
7.Super/Soft operation display
13.Sleep state display
2.Temperature display
24.Time Adjusting button
23.Sleep button
Used to set Sleep state or
Power Failure Resume
Function
When there is too much dust
collected on the air inlet, the
wire controller will show
this display to remind the
user to clean the air inlet.
After cleaning and installation,
just press the air filter reset button.
8.Fan speed display
9.Auto Swing display
11.Fresh air state display
25.Reset button
26.Air Filter Reset button
27.Timer button
Used to set the mode of
timer
28.Lock state display
4.Timer ON/OFF display
3.Clock display
17.Operation mode button
5.Humidity display
22.Setting button
Used to confirm the time
of timer and clock
15.Working mode display
21.Clock button
Used to calibrate the time of
timer and clock
16.Electric heating display
Used to set working mode:
Auto, Cooling, Dehumidifying,
Heating, Fan
18.Fan speed button
Used to set fan speed: Low
Fan, Med Fan, High Fan, Auto
20.Temperature Setting button
MODE FAN SWING
TEMP
CLOCK
TIMER
SET
SLEEP
FILTER RESET
SET
ROOM
RESET
ON/OFF
1
2
3
4
5
6
7
8
9
11
12
13
14 15 16 17 18
20
21
22
23
24
25
26
27
28
AUTO
10.Health state display
Used to set temperature,
temperature range: 16*~30*
10
19
19.Swing button
Used to set Auto Swing or
Fixed air sending direction
Calibration of clock
When turning on the unit for the first time, the clock should be calibrated. The method
of calibration is:
1.Press ìClockî button, the Clock display ìAMî ìPMî will flash.
2.Press * or * to adjust time. For each press, the time will increase or
* decrease 1
minute. If depressing the button, the time will increase or decrease * rapidly.
3.After confirming the time, press ìSetî button, ìAMî or ìPMî will stop flashing, the
clock will begin to work.
Auto
Low Fan Med Fan High Fan Auto
Working
mode Auto
operation Cooling
operation Dehumidifying
operation Heating
operation Fan
operation
Wire
controller
Name of Parts
4
Note:
This model does not
have the following
related display and
function
* * 10 11 12 28