hussmann INNOVATOR P/N 0425683F - Manual (Page 13)

LAMP (CENTER MULLION)
REPLACEMENT
Note: No additional parts need to be removed to
change out the lamps
1. Turn off lights at switch.
2. Disengage the diffuser clips from the mullion
by squeezing the diffuser cover at the clips. Two
hands may be required as shown in Figure 19.
3. Raise the diffuser slightly upward and out of
the bottom filler. Twist the bottom of the diffuser
toward the shelf and center of the door while
lowering slightly to clear the honeycomb
retainer. Pull the top of the diffuser toward the
Innovator Door Installation and
Service Instruction P/N 0425683F
11
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM
Reach-in models manufactured with Innovator
or Innovator II doors have anti-arc ballast.
When re-starting lamps, turn power off then on.
Figure 19. Disengaging Diffuser Clips
Squeeze
Here
Diffuser Clip
Always disconnect the electrical power at the
main disconnect when servicing or replacing
any electrical component. This includes, but is
not limited to, such items as doors, lights,
fans, heaters, and thermostats.
WARNING
!
Light
Switch