hussmann INNOVATOR P/N 0425683F - Manual (Page 6)

2. Unscrew the two #6 Phillips screws that hold
the black plug into the side of the door as shown
in Figure 4. Remove the plug from the door.
3. Grasp the strain relief just below the cord and
pull until the heater terminal plug comes out. See
Figure 5. Note that the left end door must be
opened more than 90 degrees to access the
screws.
4. Use a flat blade screwdriver as shown in
Figure 6 to lift the door retainer over the shoulder
screw.
5. Push down the top hinge pin until it clears the
top socket using a flat blade screwdriver as
shown in Figure 7. With finger, hold the hinge
pin in the door to keep it from popping out. Tape
may be used to temporarily hold the hinge pin
once door is removed.
P/N 0425683F ®
4
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM
Figure 4. Removing Screws to Plug
Figure 5.
Removing the Heater Terminal Plug
Remove Screws
Figure 6. Removing the Door Retainer
Door Retainer
Figure 7.
Removing the Door from the Top Hinge Pin
Top
Hinge
Pin