hussmann INNOVATOR P/N 0425683F - Manual (Page 3)

GENERAL
Be sure merchandisers have been leveled accord-
ing to the installation instructions shipped with
the merchandiser.
The door nameplate is attached to the top of the
door, handle side, behind the magnetic gasket.
The frame nameplate is located on the top left
near the switch.
ALWAYS * CLEAR ™ GLASS
Hussmann recommends using a soft cloth with
isopropyl (rubbing) alcohol to clean the inside
(coated) glass surface. Isopropyl alcohol does not
freeze and evaporates without leaving residue.
Always allow the surface to dry before closing
the door. Use of abrasives may damage the
coated surface and void the warranty. Labels
(stickers) applied to the coated surface will cause
damage and void the warranty.
SHIPPING DAMAGE
All equipment should be thoroughly examined for
shipping damage before and during unloading.
This equipment has been carefully inspected at
our factory. Any claim for loss or damage must be
made to the carrier. The carrier will provide any
necessary inspection reports and/or claim forms.
NEW INSTALLATIONS
Untape the doors and remove the shipping braces
located at top and bottom of the doors.
Doors are not fine adjusted at the factory since
they will go out of adjustment during shipment.
This is normal.
ADJUSTING CLOSING TORQUE
Adjust closing torque by turning the bottom
hinge pin in the direction the door closes. Use a
1 / 2 in. (13 mm) wrench. Turn the hinge pin until
the door closes on its own, usually 3 to 4 clicks or
3 /
4
turn. See Figure 1.
DO NOT over-torque the hinge spring assembly.
Excessive torque (over 1 full turn) will result in
damage to the spring assembly and/or door. If
door does not close on its own after one full turn
(5 clicks), look for obstructions causing the door
to hang up.
Figure 1. Adjusting Closing Torque
Innovator Door Installation and
Service Instruction P/N 0425683F
1
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM