HP B180L - Manual (Page 145)

131
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
Installing a Hard Disk Drive in Position 1 (Rear Position)
Perform the following procedure to install a hard disk drive in position 1:
1 Align the four feet on the bottom of the drive carrier with the square holes in the
storage tray, as shown in Figure 38.
Figure 38 Installing a Hard Disk Drive in Position 1 (Rear Position)
2 Set the drive in the storage tray.
3 Connect the power connector and the appropriate SCSI connector to the drive.
4 Push the drive toward the rear of the tray until the locking tab on the drive carrier
snaps into place, as shown in Figure 38.
5 Proceed to the section entitled Replacing the Storage Tray Cover on page 132.