HP B180L - Manual (Page 176)

162
Changing Your Workstation’s Hardware Configuration
Installing the Optional EGRAM (Enhanced Graphics RAM) Module
2 Line up the connector on the EGRAM module and the connector on the CPU
board while at the same time aligning the standoffs to the holes in the EGRAM
module, as shown in Figure 63.
3 Connect the EGRAM board to the CPU board. Press down firmly on the connec-
tor area and near the standoffs to make sure that the module is fully seated and
that the standoffs are fully engaged with the EGRAM module.
4 Follow the instructions in Replacing the Storage Tray on page 133
5 Follow the instructions in Replacing the Main Tray Assembly on page 112