HP B180L - Manual (Page 147)

133
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
Replacing the Storage Tray
When replacing the storage tray, use the following procedure:
1 Align the pins on the back panel of the main tray with the holes on the rear of the
storage tray and slide the storage tray onto the pins, as shown in Figure 40.
Figure 40 Installing the Storage Tray Assembly
2 Lower the front of the storage and move it slightly forward to align the pins on
its side with the slots on the main tray, as shown in Figure 40.
3 Slide the storage tray towards the rear of the main tray until the pins are fully seat-
ed in the main tray slots, as shown in Figure 40.
4 Replace and tighten the storage tray retaining screw, as shown in Figure 40.
Retaining Screw