Fire alarm system – Honeywell ADEMCO VISTA VISTA-20PSIA User Manual

Page 46

Advertising
background image

– 46 –

Fire Alarm System

THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS

General

Your fire alarm system (if installed) is on 24 hours a day, for
continuous protection. In the event of an emergency, the
strategically located smoke and heat detectors will sound their
alarms and automatically send signals to your system, triggering a
loud, interrupted pulsed sound* from the Keypad(s) and any
external sounders. A FIRE message will appear at your Keypad and
remain on until you silence the alarm (see below for silencing fire
alarms).

*

Temporal pulse sounding is produced for Fire alarms, as follows:

3 pulses–pause–3 pulses–pause–3 pulses–pause. . . , repeated.

TYPICAL FIRE EMERGENCY DISPLAYS

F I R E 0 1 M A S T E R

B E D R O O M

01

01

01

01

ALARM

FIRE

AC


ALPHA DISPLAY KEYPAD

FIXED-WORD DISPLAY KEYPAD

Silencing

Fire Alarms and

Clearing Memory

of Alarm

1. You can silence the alarm at any time by pressing the OFF key

(the security code is not needed to silence fire alarms). To clear the
display, enter your code and press the OFF key again (to clear
Memory of Alarm).

2. If the Keypad's FIRE display does not clear after the second OFF

sequence, smoke detectors may still be responding to smoke or
heat producing objects in their vicinity. Investigate, and should
this be the case, eliminate the source of heat or smoke.

3. If this does not remedy the problem, there may still be smoke in

the detector. Clear it by fanning the detector for about 30 seconds.

When the problem has been corrected, clear the display by
entering your code and pressing the OFF key.

Smoke Detector

Reset

Depending on the type of smoke detectors in your system, it may be
necessary to "reset" the smoke detectors after a fire alarm has been
turned off. Check with your installer. This "reset" is accomplished at
a keypad, as follows:

Enter User Code ( except “arm only” user), then press the [1] key.

NOTE: During smoke detector reset, “FAULT xx” appears (about six
seconds) and should disappear if the detector is clear.

Advertising
This manual is related to the following products: