Honeywell CT8775A - Manual (Page 7)

7 69-1676—1
.
Mount Decorator Cover Plate (Required) and Wallplate onto Electrical Box
❑ Pull the wires through the wiring hole on the
decorator cover plate.
❑ Place the decorator cover plate against the electrical
box so that the UP indicator in the middle of the
decorator cover plate is pointing up.
❑ Line up the screw slots on the decorator cover plate
with the electrical box screw holes, and attach the
decorator cover plate to the electrical box with two
1/2 in. screws.
❑ Pull the wires through the wiring hole on the
wallplate.
❑ Place the wallplate over the decorator cover plate.
Turn the wallplate until the wiring holes are aligned
and the two screw holes on the left and right side of
the wallplate line up with the screw holes on the
decorator cover plate.
❑ Attach the wallplate to the decorator cover plate with
the two 3/8 in. screws.
Fig. 2. Mount decorator cover plate (required) and
wallplate onto electrical box (heating-cooling wallplate
shown).
1
TROUS DE CÂBLAGE
PLAQUE D'ADAPTATION DÉCORATIVE
PLAQUE DE
COMMUTATION
VIS 1/2 PO (2)
VIS 3/8
PO (2)
BOÎTE ÉLECTRIQUE
MF19494
1 SI LA BOÎTE ÉLECTRIQUE EST
HORIZONTALE, MONTER LA PLAQUE
D'ADAPTATION DÉCORATIVE DANS
LA POSITION ILLUSTRÉE, MAIS
INSÉRER LES VIS DANS LE TROU DE
MONTAGE «A».
A