haier PH-4210D - Manual (Page 19)

Color System
B
C
A
Usually this should be set in the auto position. However if the color displayed
on the screen is incorrect, you can manually select the correct color system.
Press MENU and then VOL+/- button, till the picture menu shown on the
right will display on the screen.
Press CH+/- buttons to select "Color Sys.", then press the VOL-/+ buttons
to select the correct color system. In general, you can set it to "AUTO".
After the channels are preset, you can skip some programs to select your favorite preset channels only.
1. Press CH+/- button or Direct-digit buttons to select a channel.
2.Press MENU and then use VOL+/- button to select the SYS. Menu.
3.Press CH+/- buttons to select "Skip" item.
4. press VOL+/- button to set Skip as On.
5. When you are satisfied with your choice, press the MENU button to return to
the previous menu or press EXIT button to return to TV viewing.
1. Use Direct-digit buttons to select the number of the channel to
be recovered.
2. Do the above steps again.
3. Press VOL+/- button to set Skip as Off.
Skip
B
C
A
If you want to recover the skipped channel
System Menu
Owner s Manual 19
Color Sys. AUTO
Sound Sys. M/N
Fine Tune 49.75MHz
Skip Off
Channel Type Cable
CATV Type STD
Auto Scan
Color Sys. AUTO
Sound Sys. M/N
Fine Tune 49.75MHz
Skip Off
Channel Type Cable
CATV Type STD
Auto Scan
Fine Tune
B
C
A
If the picture and/or sound are poor, try using the fine tune feature.
Do not use this feature unless reception is poor.
1 Repeat step 1-2, then press CH+/- buttons to select "Fine Tune" item.
2 Press VOL+/- buttons repeatedly to carry out fine tune, until the best
picture and sound are obtained, then release the button.
Color Sys. AUTO
Sound Sys. M/N
Fine Tune 49.75MHz
Skip Off
Channel Type Cable
CATV Type STD
Auto Scan