Hama VPL-CX86 - Manual (Page 5)

C:\data\Projector\AirShot\AirShot_FMData\2634400112_VPL-
CX8676_AirShot\2634400112_VPL-
CX8676_AirShot\2634400112\2634400112VPLCX8676WW\02C01.fm masterpage: Right
5
Preparation
VPL-CX86/CX76
2-634-400-11 (1)
The USB wireless LAN module
contains memory. You can switch the
built-in memory and wireless
connection with the slide switch. To
install the Projector Station for Air Shot
Version 2, slide the switch to
MEMORY. To use the wireless
connection, slide it to WIRELESS LAN.
2
Connect the supplied USB wireless
LAN module to the USB terminal of
the computer.
The window for installing the Projector
Station for Air Shot Version 2 appears.
• If the above window does not appear,
click [My Computer]-[USB_CD-ROM]-
[Dp_Inst].
• You cannot refer to the Operating
Instructions. See the Operating
Instructions from the CD-ROM.
3
Select [Projector Station for Air Shot
Version 2] and then click [Install].
4
Install the software according to the
“wizard” within the installer.
5
Use [Safe to remove hardware] to stop
the device and then remove the USB
wireless LAN module. Then slide the
switch to [WIRELESS LAN] and
connect the USB wireless LAN
module into the USB terminal.
When you use Windows XP Service
Pack 2 and the following dialog box
appears during installation, check the
[Register automatically] check box and
click [Next].
The [Autoconfiguration done] appears
after the installation is completed.
6
To go on projecting the pictures, check
the [Start Air Shot v2 and connect to
Projector] check box and click [OK].
With the check, the Projector Station for
Air Shot Version 2 starts up
automatically. Without the check, the
installer is completed.
When you are not going to project the
pictures, click [OK].
Notes
WIRELESS
LAN MEMORY
USB
wireless LAN module (supplied)
Computer