Wiring complete, return to step 8, About your new thermostat, Wiring—heat pump – Honeywell RTH6350 User Manual
Page 26
Advertising
Advanced Installation Guide
69-2416ES—05 24
About your new thermostat
SETUP
WIRING
ASSIST
ANCE
TROUBLESHOOTING
Wiring—Heat Pump
Connect wires: Heat Pump
1. Match each labeled wire with same letter on new
thermostat.
2. Use a screwdriver to loosen screws, insert wires into
hole under screw, then tighten screws until wire is
secure.
3. If E and Aux do not each have a wire connected,
use a small piece of wire to connect them to each
other.
4. Push any excess wire back into the wall opening.
Labels don’t match?
See page 26.
Wiring complete, return to Step 8.
HEAT PUMP
MCR31276
AUX
Aux
O/B
E
L
G
Y
G O
Y R
R
Rc
Advertising
This manual is related to the following products: