Hitachi HV-D30 - Manual (Page 43)

9) SC.FINE : Fine adjustment of subcarrier phase
The allowable setting range is -128 to 127.
There is no direct relationship between a numeric value and a degree of phase. If
the relevant range is exceeded, the SC COARSE setting is updated automatically to
permit continuous adjustment.
10) H.PHASE : Adjustment of horizontal synchronization phase
The allowable setting range is -128 to 127.

15. File set
Use for transferring scene file data to another file or setting all data to preset values.
1) FILE SELECT : Selects scene file 1 - 4 or preset for copy data.
2) STORE FILE : Selects file for storing scene file data.
3) STORE : Press L and R for more than 1 second to transfer selected scene file data
to store file.
4) STORE PRESET : Press L and R for more than 1 second to initialize selected scene
file data to preset values.
5) All INITIALIZE : Press L and R for more than 1 second to initialize all scene file
data to preset values.

16. OTHER FUNC

1) FLARE : Flare compensation on/off
Corrects for extraneous reflections in the optical and CCD systems which end to
weaken bright image components. Normally set to on.
2) FLARE LEVEL: Setting range is -128 (smaller) to 127 (larger compensation).
Press L and R for about 2 seconds to set to 0.
3) KNEE POINT: Use L and R to set in the range -128 (smaller) to 127 (larger). Press
both L and R for about 2 seconds to set to 0. Normally set to where
gradation appears above 100% video level.
4) WHITE CLIP : Sets white clip level
Use L and R to set in the range of -128 (lower) to 127 (higher) clip level. Press both
L and R for about 2 seconds to set to 0. Normally set for clip at about 110% video
level. Adjust when there is excess video level from the equipment interface.

30