Hitachi HV-D30 - Manual (Page 52)

RC-Z3 Remote Control Panel
All camera menu items can be operated remotely by connecting the RC-Z3 Remote Control
Panel. Connect the panel as follows.
(1) Set camera internal switch SW806 to RC-Z3.
See internal switch selection on page 45 .
(2) Open the SPECIAL SET menu and set the camera communications rate to 9600 bps
(see page 31, factory setting).
Operation
(1) Direct control
The following items can be controlled directly as well as from the control panel.
࡮BAR/CAM ࡮ULTRA GAIN(ON/OFF) ࡮M.BLK
࡮WHITE BAL ࡮ENABLE(ON/OFF) ࡮A.WHT
࡮GAIN ࡮R GAIN ࡮A.BLK
࡮DTL ࡮B GAIN ࡮SCENTE FILE
࡮IRIS MODE ࡮R BLK
࡮SHUTTE(ON/OFF) ࡮B BLK
࡮CONTRST(ON/OFF) ࡮IRIS
(2) MENU controls
All control items are set from menu. Press the FUNCTION button of the remote control
panel to produce the menu mode and display the MAIN MENU screen. Again press the
FUNCTION button to extinguish the menu screen and return to the direct mode.
Operate the menu with the UP, DOWN, LEFT and RIGHT buttons.
Note: While pressing the UP button presses the FUNCTION button for 2 seconds to
produce the special set mode. The SPECIAL SET menu appears.
(3) Setting data store
Setting data (menu and direct control items) are not automatically stored when using the
RC-Z3. Press the RC-Z3 STORE button and the SCENE FILE button of the location for
storing the data.
Note: Use care since the data are lost if the application is changed or the power cut off
without storing.
39