Hitachi HV-D30 - Manual (Page 45)

࡮
BOTTOM : Displayed at the lower left corner of screen.
3) DATA SET : The DATA SET screen comes up.
ID : Enter an ID code consisting of three characters.
Alphanumeric upper-case characters and a space character are permitted.
TITLE : Enter a TITLE consisting of up to 12 characters.
Alphanumeric upper-case characters, special symbols and a space
character are permitted.
Note: The symbol " " in the data represents a space character. On the
actual screen, a space character is given as a blank in an ID code or TITLE.
<ID/TITLE Setup Procedure>
i) With the cursor located at DATA SET, press the D button. The cursor moves to
the ID data set position an the first character flashes.
ii) Using the L, R, U and D buttons, select an input character.
iii) Press the SET UP button, and the selected character will be entered. (The cursor
will then move to the next character position.)
iv) In the same manner, repeat the above steps ii) and iii) to enter an ID code and
TITLE.
v) On completion of character input, bring the cursor to RET using the L, R, U or D
button. Then, press the SET UP button.
The cursor is returned to DATA SET.
vi) To quit the SPECIAL SET mode, press the SET UP button.
<- : Flashing shifts one character toward the left.
-> : Flashing shifts one character toward the right.
DEL : Flashing character is deleted, and the subsequent character string is shifted
left.
INS : A space is inserted at the flashing character position, and the subsequent
character string is shifted right.
RET : The cursor is returned to DATA SET.


32