Document Outline

• Perfecto2™Series
  • Oxygen Concentrators without SensO2®, Oxygen Concentrators with SensO2
  • HomeFill™Compatible
  • Model IRC5PO2
  • Model IRC5P
  • m warning
  • accessories
  • special Notes
• NOTICE
  • The information contained in this document is subject to change without notice.
  • c danger
  • Section 1- General guidelines
  • Section 2- Features
  • Oxygen Outlet
    • Section 3- Handling
    • Section 4- typical product parameters
      • *NOTE: Stated concentration levels achieved after initial warm-up period (approximately 30 minutes).
    • IRC5PO2 Indicators
      • Label
      • Symbol
      • o2 Purity
      • IndicaTor Lights (LED)
    • IRC5P indicators
      • Label
      • Symbol
      • Status
      • IndicaTor Lights (LED)
      • Section 5- Operating Instructions
        • Introduction
        • Select a Location
        • Recommended Guidelines for Optimum Performance
        • Plug in Power Cord
          • 1. Plug in power cord to an electrical outlet.
          • Connect Humidifier (If So Prescribed)
            • m WARNING
  • Humidifier Bottle w/o Cap
    • FIGURE 5.1 Filling the Humidifier
  • Insert Flat Head Screwdriver Here
    • FIGURE 5.2 Humidifer Bottle Adapter
  • Humidifier Bottle
    • FIGURE 5.3 Humidifier Compartment
    • Power Switch
      • NOTE: For this procedure, refer to FIGURE 5.4.
  • On/Off (I/O) Power Switch
    • FIGURE 5.4 Power Switch
    • Flowrate
      • NOTE: For this procedure, refer to FIGURE 5.5 on page 22.
      • 1. Turn the flowrate knob to the setting prescribed by your physician or therapist.
        • m WARNING
        • DO NOT change the L/min setting on the flowmeter unless a change has been prescribed by your physician or therapist.
  • Flow Knob
    • FIGURE 5.5 Flowrate
    • SensO2 Oxygen Purity Indicator (If Your Unit Features the O2 Sensor Feature)
    • Initial Startup of the Concentrator
    • Explanation of Oxygen Purity Indicator Lights - Model IRC5PO2
      • NOTE: For this procedure, refer to FIGURE 5.6.
      • GREEN light (O2) - Normal Operation.
    • Auto Shut Down
    • Use Backup
      • FIGURE 5.6 SensO2 Oxygen Purity Indicator (If Your Unit Features the O2 Sensor Feature)
      • Indicators (If Your Unit Does Not Feature the O2 Sensor)
        • NOTE: For this procedure, refer to FIGURE 5.7.
        • IRC5P Model Indicator Light Explanation
          • RED light () - Total Unit Shut-Down. Switch IMMEDIATELY to a back-up oxygen supply. Call supplier IMMEDIATELY.
          • GREEN light (I/O) - On/Off. System okay.
    • Auto Shut Down
    • Use Backup
      • FIGURE 5.7 Indicators (If Your Unit Does Not Feature the O2 Sensor)
      • Section 6- Maintenance
    • Preventive Maintenance Record
      • Model No. IRC _______________________________
      • Serial No.____________________________________
      • On Each Inspection
        • *NOTE: Refer to Preventive Maintenance section of Service Manual.
      • Section 7- TROUBLESHOOTING GUIDE
        • Symptom:
        • Probable Cause:
        • Solution:
          • Part No 1143482
  • LIMITED WARRANTY
    • NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.