Heatiator CB4842IR - Manual (Page 29)

Heatilator • Caliber BV Series • 4040-262 • Rev M • 08/09 29
A. Remove Glass Assembly
See Section J.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories .
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
G. Place the Rockwool
WARNING! Risk of Explosion! Follow rockwool placement
instructions. DO NOT place rockwool directly over burner
ports. Replace rockwool material annually. Improperly
placed rockwool interferes with proper burner operation.
• Rockwool is shipped with this gas appliance.
• Place a small amount of /2 in. diameter pieces
(dime-size) of rockwool on the burner pan so that rock
wool touches but does not cover the holes in the burner
pan.
• It is not necessary to use the entire bag. Save the
remaining amount for future use.
E. Install the Refractory
An optional weathered brick refractory is available for this
appliance. Follow the installation instructions supplied
with the refractory.
14
Appliance Setup
Figure 14.1 Placement of Lava Rock
Figure 14.2 Placement of Vermiculite
Rock wool
placement
(shaded areas)
Vermiculite and
lava rock
placement on
sides and front
of hearth pan.
Vermiculite and
lava rock
placement on
sides and front
of hearth pan.
Figure 14.4 Placement of Lava Rock, Vermiculite & Rock Wool
F. Place the Lava Rock & Vermiculite
• See Figures 4.. 4.2. and 4.4.
• It is not necessary to use the entire bag of either product.
Save the remaining amount for future use.
Figure 14.3 Placement of Rock Wool