Snmpv3 enable, Snmpv3 enable -7 – HP 2600 User Manual
Page 261
Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
SNMPv3 Enable
The
snmpv3 enable command starts a dialog that performs three functions:
enabling the switch to receive SNMPv3 messages, configuring the initial users,
and, optionally, to restrict non version-3 messages to “read only”. Figure 13-1
shows and example of this dialog.
N o t e :
For most SNMPv3 management software to be able to create new users, they
S N M P
must have an initial user record clone. These records can be downgraded,
V e r s i o n 3
(given fewer features), but not upgraded with new features added. For this
I n i t i a l U s e r s
reason HP recommends that you create a second user with SHA and DES at
when you enable SNMPv3
Enable
Create initial user models for SNMPv3
management applications.
Set restriction on
non-SNMPv3 messages.
Figure 13-1. Example of SNMP version 3 Enable Command
13-7