Hearth and Home Technologies Heat-N-Glo Dakota 42 - Manual (Page 12)

12 Heat-N-Glo Lifestyle Collection • Dakota 42/Dakota 42H • 4036-905 Rev I • 10/05
E. Valve Access
Figure 6.1 Loosen Refractory Retaining Strip
Figure 6.2 Lift Out Doors
Figure 6.3 Remove Valve Access Panel
Figure 6.4 Remove Exterior Valve Access Panel
Figure 6.5 Connect Manometer
• The gas valve can be accessed behind the cement
refractory panel on the right side of the fi replace. Use a
phillips screwdriver to remove the two screws securing
the refractory retaining strip.
• Lift doors out and set aside. Remove the refractory side
panel and set aside.
• Remove the inside valve access panel by lifting it up and
out.
• Use a phillips screwdriver to remove the exterior valve
access panel.
• Use a manometer on the lower out pressure tap. Start
up the fi replace to verify the pressure and adjust as
necessary. Reverse these steps to reassemble before log
positioning.