HP 6000 - Manual (Page 36)

36
Important---- If you are using a VNA this information does not apply to you.
Performing a Scalar Calibration
1. Be sure Platform Power supply is securely attached and plugged in
3. Turn Platform Power ON.
4. Selet the Source Instrument you plan to use, After selection click the “Settings” button located below the icon.
5. Click the “Cal System button
6. Connect the power meter to the top of the DAMs System.
7, Press the left “Begin Calibration” button, Follow on screen directions.
Chapter 3 - Making Measurements System Calibration