HP 6000 - Manual (Page 42)

42
Viewing and working with measurements in 3D
Press any of the 3D Buttons to View the “Active Register” Data in 3D Using the MatLab Viewing Interface.
Viewing 3D Azimuth Measurements
Viewing 3D Az/El Measurements
1. Be Sure there is data in the “Active Register, if there is no data
you must recall data from one of the storage registers or make a
Measurement.
2. Press the “View 3D Az Plot” button.
3. Depending on the size of your measurement and the speed of
your computer it may take up to 2 minutes for your 3D plot to
appear on the screen.
1. Be Sure there is data in the “Active Register, if there is no data
you must recall data from one of the storage registers or make a
Measurement.
2. You can only view 1 frequecy at a time using the Az/El 3D
Plots, when you press the “View 3D Az/El” measurements you
will be prompted to choose a frequency to view.
3. Depending on the size of your measurement and the speed of
your computer it may take up to 2 minutes for your 3D plot to
appear on the screen.
QUICK TIP: Use the Amplitude plot to get a reference of the
frequency response of the antenna.
Working With 3D Data
To Rotate a Plot- Click Tools -> Rotate 3D
To Print a Plot- Click File->Print
To Label a Plot- Click Tools -> Add -> Text
To save a Plot- Click File -> Save (Saved File compatible with matlab viewer only)
To Export as BMP Image File- Click File -> Export
Below are a few common functions that you can do with the 3D plots.
Data Processing Feature Chapter 4 - Using the Data Processing Feature