HP XE3 - Manual (Page 46)

2-18 Removal and Replacement HP OmniBook XE3
Figure 2-12. Removing the Display
Reassembly Notes
•
While installing the hinge screws, support the display so that it remains approximately flat.
•
Before installing the switchboard PCA, make sure the large display cable lies within the notch in
the hinge saddle.
•
When in stalling a new display assembly, follow the procedure given in “Installing a New Display
Assembly” on the following page.
Screws,
M2.5x4 mm
Screws (flanged)
M2.5x8 mm (4)