FUJITSU fi-4750L - Manual (Page 82)

7-14
17. Adjust ADF Erasing Edges
<Screen 57>
1 Press “Next” or “Previous” and let
the scanner display Screen 57.
2 At Screen 57, press or to select
“Yes” and press . Then the scanner
displays Screen 57-1.
<Screen 57-1>
3 At Screen 57-1, select “Yes” to return the
settings to the factory default or select
“No” to make new settings (as shown
below). Then press
. The scanner
displays Screen 57-2.
<Screen 57-2>
4 At Screen 57-2, press or to change
the top setting. The value changes in 1
mm units. Then press
to activate
the setting. The scanner displays Screen
57-3.
<Screen 57-3>
5 At Screen 57-3, press or to change
the bottom setting. With (+:Up), the area
is set upward from the bottom edge of the
image. With (–:Down), the area is set
downward from the bottom edge of the
image. The value changes in 1 mm units.
Then press
to activate the setting.
The scanner displays Screen 57-4.
<Screen 57-4>
6 At Screen 57-4, press or to change
the left setting. The value changes in 1
mm units. Then press
to activate
the setting. The scanner displays Screen
57-5.
<Screen 57-5>
7 At Screen 57-5, press or to change
the top setting. The value changes in 1
mm units. Then press
to activate
the setting. The scanner displays the
next setup item.