Furman Sound HDS-16 - Manual (Page 3)

HDS-16/HRM-16 HEADPHONE DISTRIBUTION SYSTEM
matically mute all HRM-16 sends except the
channel D stereo and talkback outputs. This
unique feature allows each musician to hear a
rough or fi nal mix and send soloed tracks from
the mix console. This eliminates the need for
musicians to relocate to the control room or
manually change their HRM-16 level settings.
Note: Both the solo func tion on the HDS-16 and
the talkback system on the HRM-16 can be ac ti -
vat ed man u al ly using their front panel con trols or
by op tion al remote switch es.
ADDITIONAL USEFUL HRM-16
FEATURES INCLUDE
■
local effects send and return;
■
line out (mono);
■
bass and treble shelving EQ controls;
■
talkback level and master volume controls.
HDS-16 HEADPHONE/
AUDIO DISTRIBUTION
SYSTEM
The HDS-16, a 2-U rack-mountable device
normally located near the main mixing console,
provides the power and signal conditioning
for a maximum of eight HRM-16’s. Individual
channel sends from the console connect to the
HDS-16 inputs.
FRONT PANEL
The front panel serves as the patch bay for all
input connections: eight mono and four stereo
¼-inch and TT input connectors. All connec-
tors are balanced and use the Tip/Ring/Sleeve
(TRS) wiring convention. Both ¼-inch and TT
connectors can be used but not for the same
channel. If both con nec tor types are used for
the same channel, the TT connector will be ac-
tive and ¼-inch connector will be disabled.
TALKBACK
Figure 2 shows the TALKBACK connectors at
the far left of the front panel. Connect the mix
con sole’s line-level, talkback-microphone out-
put or cue send to the HDS-16’s ¼-inch INPUT
jack. This signal is distributed to the HRM-16s
on the Centronics cable along with the other
channels. Use the RETURN FROM HRM-16
connector to monitor talkback from the HRM-
Figure 1: HDS-16 front panel
The front panel is shown above; the TT and ¼-inch input sections are shown in detail in Figure 2
and Figure 4, respectively. Note: Although the POWER indicator LED is located on the far right
of the HDS-16 front panel, the AC power ON/OFF switch is on the rear panel.
2