Fostex FM-3 - Manual (Page 15)

Press the [+] key
Press the [+] key
Press the [+] key
Press the [-] key
Press the [-] key
In the status display mode, not only you can check the
status for the input, output, meter and system, but also
you can edit setting.
(1) Press the [STATUS] key long enough to enter the
status display mode.
The display shows the input status display.
(2) Press the [+] or [-] key to select the desired status
display.
(3) Press the [EDIT] key to exit the status display
mode.
For details about the contents of each status display
and parameter setting, see the next page.
Press the [+] key Press the [-] key
You can select the meter mode from stereo, mono L
and mono R. By default, it is set to the stereo mode.
The meter mode setting remains even after you turn
off the unit. If you initialize the flash memory using the
system status display, it is reset to the default setting (see
page 20).
(1) Press the [METER] key long enough to enter the
meter select mode.
The meter mode icon is shown at the bottom of the
display.
(2) Press the [+] or [-] key to select the desired meter
mode.
(3) Immediately after selecting the desired meter
mode, press the [EDIT] key to exit the meter
select mode.
Press the [+] key Press the [-] key
Selecting the meter mode Selecting the status display
Press the [-] key
System status display
Meter status display
Output status display
Input status display
Stereo meter mode
Mono meter (L) mode
Mono meter (R) mode
<Note>: If you do not press any key for approxi-
mately five seconds while the meter mode icon is
shown, the icon automatically disappears and the
unit exits the meter select mode.
15