Friedrich P/N9368987060-01 - Manual (Page 5)

En-4
OPERATION
Press the ENERGY SAVE button to start or stop the energy-sav-
ing air conditioner operation.
For details on the function, refer to page 9.
ENERGY
SAVE
THERMO
SENSOR
Room temperature sensor selection
Press the THERMO SENSOR button to select whether the
room temperature is detected at the indoor unit (remote
sensor) or the remote controller.
When the thermo sensor display appears, the room
temperature is detected at the remote controller.
NOTES
• This function is locked at the factory. In order to detect the room temperature correctly, consult authorized service
personnel when using this function.
• If this function is locked, the location where the room temperature is detected cannot be changed and the
mark flashes when the THERMO SENSOR button is pushed.
Indoor unit
Energy save
Part lock function
DAY OFF
DELETE SET
SET BACK
DAY
CLOCK ADJUST
Press the DAY (DAY OFF) button and SET button simulta-
neously for 2 seconds or more to activate the part lock
function and lock all of the buttons on the remote con-
troller except the Start/Stop button, Set Temperature but-
tons, Master Control button, and Fan Control button. Press
the buttons again for 2 seconds or more to deactivate the
part lock function.
When the part lock function is activated, the
mark
appears. If any button is pressed during the part lock, the
PL display flashes.
9368987060-01_OM_en.p65 2/4/10, 4:45 PM 4