FMI FVF24P - Manual (Page 14)

14 105192
UNVENTED PROPANE/LP GAS LOG HEATER
INSTALLATION
Continued
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place one-piece log set on grate to fit
as illustrated in Figure 17. Make sure
bottom of front log is in front of “U”-
shaped cutout in center of chassis (see
Figure 17).
IMPORTANT: Make sure log does not
cover any burner ports.
2. Place lava rock on fireplace floor
around base of heater.
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Figure 17 - Installing Heat Majic™ One-
Piece Log Set
Figure 18 - Installing Heat Majic™ One-
Piece Log Set (Top View)
One Piece
Log Set
Burner
Ports
One Piece
Log Set
Burner
"U"-shaped
Cutout in
Chassis
Chassis