Frymaster SDU 50 - Manual (Page 7)

4
DANGER
DO NOT OVERFILL! Do not fill the reservoir above the fill lines on the sides of the
reservoir. Moving the SDU with an overfilled reservoir may result in spills and injury
to personnel who come in contact with the spilled shortening.
4. Carefully withdraw the unit far enough to allow the cover to be closed. Latch the cover in the
closed postion. Using the handle, carefully tip the unit back slightly for ease of handling and roll
the unit to the disposal site.
WARNING
DO NOT use the pump or discharge piping assembly as a handle!
DANGER
To minimize the potential for burns, oil must always be allowed to cool below 100°F
(38°C) before draining into the SDU and transporting to the disposal area. However,
DO NOT allow shortening to solidify in the SDU.
The unit is designed to be moved, when properly filled, at an average walking pace on a flat
surface. Care must be taken at all times when moving hot shortening or oil. Rough terrain or
sudden stops and starts may cause the contents of the reservoir to spill or splash out of the
reservoir, possibly causing serious injury to personnel. Always ensure that the cover is latched
shut when moving the unit.
5. At the disposal site, lift the pump assembly lock pin and rotate the discharge pipe as necessary to
position the discharge nipple over the opening of the disposal container. Release the lock pin to
secure the pump assembly in position. Turn the pump handle clockwise. The pump should start
discharging oil after a few turns. Continue turning the handle until the MSDU reservoir is empty.
6. On BKSDU units, the built-in heater may be connected to a grounded 120VAC or 240VAC
receptacle to prevent shortening from solidifying in the tank when immediate transfer to a
disposal container is not possible.
2.4 Cleaning
Clean the crumb screen with a solution of detergent and water. Clean the exterior surfaces of the
SDU with a soft cloth and a solution of detergent and water. It is not necessary to clean the interior
of the reservoir, but if desired it may be wiped down with clean paper towels to remove excess
residual shortening.