Fujitsu Siemens Computers LifeBook B6220 - Manual (Page 18)

18
L i f e B o o k B S e r i e s N o t e b o o k B I O S
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security
features of your notebook to fit your operating needs and
to view the current data security configuration. Follow
the instructions for Navigating through the Setup Utility
to make any changes.
The following tables show the names of the menu fields
for the Security menu and submenus, all of the options
for each field, the default settings and a description of the
field's function and any special information needed to
help understand the field's use. The default condition is
no passwords required and no write protection.
Figure 11. Security Menu
• If you set a password, write it down and
keep it in a safe place. If you forget the
password you will have to contact your
support representative to regain access
to your secured functions and data.
• If you make an error when re-entering
the password a [Warning] will be
displayed on the screen. To try again,
press the Enter key and then retype the
password. Press the Esc key to abort the
password setting process.
• Boot sector protection must be set to
[Normal] to install or upgrade an oper-
ating system.
• Entering a password incorrectly three
times in a row will cause the keyboard
and mouse to be locked out and the
warning [System Disabled] to be
displayed. If this happens, restart the
computer by turning off and on the
power with the power switch and use
the correct password on reboot.
• If the Password on Resume is Enabled
and the Password on Boot is Disabled
you will not have to type your pass-
word upon resuming the system from
the Standby or Hibernate modes.
Power Management Security will work
only if Password on Boot is enabled.
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
▲
Main Advanced Security Boot Info Exit
Item Specific Help
Press <Enter> key to
set Supervisor password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
PhoenixBIOS Setup Utility
Supervisor Password Is: Clear
User Password Is: Clear
Set Supervisor Password [ Enter ]
Set User Password [Enter]
Minimum User Password Length [0]
Password on Boot: [Disabled]
On Automatic Wake up: [Disabled]
KB Lock on Resume: [Disabled]
Boot from Removable Media: [All]
Flash Write: [Enabled]
Hard Disk Security
Owner Information
Security Chip Setting
Security Panel on Resume: [Enabled]
▲
▲
▲