FUJITSU x178 - Manual (Page 7)

English
6
WARNING!
Before you start cabling your display unit, check that the
power is off on all units. To avoid any possibility of electric
shock, always connect your equipment to properly earthed
outlets.
The base of the display is already installed; do not use the
monitor withour it. Place the display unit on a level and sturdy
surface.
Connect the display unit’s signal cable (a) to the system unit
and scure it with the two screws. The connector pins may be
protected against damage by a plastic cover which needs to
be removed first.
Plug the display unit’s power cable (b) first to the back of the
display unit, as shown below.
Then plug the power cable (b) to a 100V-240V earthed
electrical outlet or to the system unit, if it has an outlet for the
display power cable, as shown below.
Installing your display unit
1 .
2 .
3 .
4 .
Fujitsu 8/16/92 5:16 PM Page 9